Re: [Qemu-devel] [PATCH v5-resend 2/2] mips_fulong2e: Add on-board graphics chip

[Philippe Mathieu-Daudé]

On 3/8/19 5:22 PM, BALATON Zoltan wrote:
> On Fri, 8 Mar 2019, Gerd Hoffmann wrote:
>> On Thu, Mar 07, 2019 at 01:32:41AM +0100, Philippe Mathieu-Daudé wrote:
>>> On 3/6/19 9:05 PM, BALATON Zoltan wrote:
>>>> Add (partial) emulation of the on-board GPU of the machine. This
>>>> allows the PMON2000 firmware to run and should also work with Linux
>>>> console but probably not with X yet.
>>>>
>>>> Signed-off-by: BALATON Zoltan <address@hidden>
>>>> Reviewed-by: Philippe Mathieu-Daudé <address@hidden>
>>>> Tested-by: Philippe Mathieu-Daudé <address@hidden>
>>>
>>> Mojibaked again :(
>>
>> Mail was sent without Content-Type: header.  Both mutt and "git am" on
>> my machine assume utf-8 and everything looks fine.  I guess your mail
>> client assumes something else ...
> 
> So it came out good at the end but that depends on what maintainer's
> config does by default it seems.
> 
>> "git send-email" should send the patches with correct headers, it even
>> asks for the charset it should use in case it finds non-ascii
>> characters.  So BALATON, could you check your mail client config, or
>> switch over to "git send-email" for submitting patches?
> 
> I'm sending what git format-patch is generating and that does not add
> content type header by default. Is there a config option to enable that?
> I can't use git send-email because I'm sending from different machine
> than I use git on.

On another thread Laurent Vivier found it is a copy/paste problem
between an email client and an editor (IIUC):
https://lists.gnu.org/archive/html/qemu-devel/2019-02/msg03669.html

Laurent, if you understood what's wrong, can you add en entry in the
wiki so we can refer contributors to it?

Thanks,

Phil.