Re: [Qemu-devel] [PATCH] RISC-V - Dynamic parameterization of RISC-V memory map

[Michael Eager]

Corrected patch attached.

On 08/29/2018 05:48 PM, Michael Eager wrote:
> Whoops.  I just noticed that this patch is against the riscv-qemu
> repo on github, not the qemu.org repo.  I will rework it for the 
> qemu.org repo.  Meanwhile, I welcome any comments.
>
> On 08/29/2018 05:21 PM, Michael Eager wrote:
> > Memory parameters for RISC-V boards can be read from a configuration
> > file using the -readconfig command line option.  The configuration file
> > should have a section for the board and memory.  The configuration for
> > the VirtIO board has the following configuration variables:
> > [riscv-virt-mem]
> >    debug-base   = "0x0"
> >    debug-size   = "0x100"
> >    mrom-base    = "0x1000"
> >    mrom-size    = "0x11000"
> >    test-base    = "0x100000"
> >    test-size    = "0x1000"
> >    clint-base   = "0x2000000"
> >    clint-size   = "0x10000"
> >    plic-base    = "0xc000000"
> >    plic-size    = "0x4000000"
> >    uart0-base   = "0x10000000"
> >    uart0-size   = "0x100"
> >    virtio-base  = "0x10001000"
> >    virtio-size  = "0x1000"
> >    dram-base    = "0x80000000"
> >    dram-size    = "0x0"
> >
> > Values must be enclosed within quotes.
> >
> > Signed-off-by: Michael Eager <address@hidden>

--
Michael Eager    address@hidden
1960 Park Blvd., Palo Alto, CA 94306

0001-RISC-V-Dynamic-parameterization-of-RISC-V-memory-map.patch
Description: Text Data