Re: [Qemu-devel] [Qemu-arm] [PATCH 15/16] hw/dma/pl080: Remove hw_error() if DMA is enabled

[Philippe Mathieu-Daudé]

On 08/09/2018 10:01 AM, Peter Maydell wrote:
> The PL08x model currently will unconditionally call hw_error()
> if the DMA engine is enabled by the guest. This has been
> present since the PL080 model was edded in 2006, and is
> presumably either unintentional debug code left enabled,
> or a guard against untested DMA engine code being used.
> 
> Remove the hw_error(), since we now have a guest which
> will actually try to use the DMA engine (the self-test
> binary for the AN505 MPS2 FPGA image).
> 
> Signed-off-by: Peter Maydell <address@hidden>

Reviewed-by: Philippe Mathieu-Daudé <address@hidden>

> ---
>  hw/dma/pl080.c | 1 -
>  1 file changed, 1 deletion(-)
> 
> diff --git a/hw/dma/pl080.c b/hw/dma/pl080.c
> index 8f92550392b..ef15d3e628d 100644
> --- a/hw/dma/pl080.c
> +++ b/hw/dma/pl080.c
> @@ -110,7 +110,6 @@ static void pl080_run(PL080State *s)
>      if ((s->conf & PL080_CONF_E) == 0)
>          return;
>  
> -hw_error("DMA active\n");
>      /* If we are already in the middle of a DMA operation then indicate that
>         there may be new DMA requests and return immediately.  */
>      if (s->running) {
>