Re: [Qemu-devel] [PATCH] s390x/pci: forbid multifunction pci device

[Thomas Huth]

On 14.03.2018 06:14, Yi Min Zhao wrote:
> Currently we don't support pci multifunction. If a pci with
> multifucntion is plugged, the guest will spin forever. This patch fixes
> this.
> 
> Signed-off-by: Yi Min Zhao <address@hidden>
> Reviewed-by: Pierre Morel <address@hidden>
> ---
>  hw/s390x/s390-pci-bus.c | 10 ++++++++++
>  1 file changed, 10 insertions(+)
> 
> diff --git a/hw/s390x/s390-pci-bus.c b/hw/s390x/s390-pci-bus.c
> index 77a50cab36..10da87458e 100644
> --- a/hw/s390x/s390-pci-bus.c
> +++ b/hw/s390x/s390-pci-bus.c
> @@ -816,6 +816,11 @@ static void s390_pcihost_hot_plug(HotplugHandler 
> *hotplug_dev,
>          PCIBridge *pb = PCI_BRIDGE(dev);
>          PCIDevice *pdev = PCI_DEVICE(dev);

Off-topic: That "PCIDevice *pdev" shadows the pdev variable that is
declared at the beginning of this function. So I think we should rather
change the above line into "pdev = PCI_DEVICE(dev)" instead, without
re-declaring a variable here. (i.e. we should do this in a separate
patch later...).

> +        if (pdev->cap_present & QEMU_PCI_CAP_MULTIFUNCTION) {
> +            error_setg(errp, "multifunction not supported in s390");
> +            return;
> +        }
> +
>          pci_bridge_map_irq(pb, dev->id, s390_pci_map_irq);
>          pci_setup_iommu(&pb->sec_bus, s390_pci_dma_iommu, s);
>  
> @@ -835,6 +840,11 @@ static void s390_pcihost_hot_plug(HotplugHandler 
> *hotplug_dev,
>      } else if (object_dynamic_cast(OBJECT(dev), TYPE_PCI_DEVICE)) {
>          pdev = PCI_DEVICE(dev);
>  
> +        if (pdev->cap_present & QEMU_PCI_CAP_MULTIFUNCTION) {
> +            error_setg(errp, "multifunction not supported in s390");
> +            return;
> +        }
> +
>          if (!dev->id) {
>              /* In the case the PCI device does not define an id */
>              /* we generate one based on the PCI address         */
> 

Reviewed-by: Thomas Huth <address@hidden>