[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] MTD timeout on bootup
From: |
James Hanley |
Subject: |
[Qemu-devel] MTD timeout on bootup |
Date: |
Fri, 31 Mar 2017 11:28:31 -0400 |
When trying to bootup a pristine zync image from the zc702 tarball, it
would always fail with the MTD detection of the serial flash device type
command over the SPI. I believe this section of code may have the logic
flipped. Once I changed it to the following, I was able to detect the
flash type when booting the pristine image from Xilinx.
-Jim
>From baaaacca370c13526fd2b8c7b33c7d9e8a6d7b8d Mon Sep 17 00:00:00 2001
From: Jim Hanley <address@hidden>
Date: Thu, 23 Mar 2017 10:29:34 -0400
Subject: [PATCH] MTD writes from the SPI were never being dequeue...
Signed-off-by:
---
hw/ssi/xilinx_spips.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/hw/ssi/xilinx_spips.c b/hw/ssi/xilinx_spips.c
index da8adfa..a3af1f7 100644
--- a/hw/ssi/xilinx_spips.c
+++ b/hw/ssi/xilinx_spips.c
@@ -482,8 +482,8 @@ static void xilinx_spips_write(void *opaque, hwaddr
addr,
s->regs[addr] = (s->regs[addr] & ~mask) | (value & mask);
no_reg_update:
xilinx_spips_update_cs_lines(s);
- if ((man_start_com && s->regs[R_CONFIG] & MAN_START_EN) ||
- (fifo8_is_empty(&s->tx_fifo) && s->regs[R_CONFIG] &
MAN_START_EN)) {
+ if (!((man_start_com && s->regs[R_CONFIG] & MAN_START_EN) ||
+ (fifo8_is_empty(&s->tx_fifo) && s->regs[R_CONFIG] &
MAN_START_EN))) {
xilinx_spips_flush_txfifo(s);
}
xilinx_spips_update_cs_lines(s);
--
2.7.4
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Qemu-devel] MTD timeout on bootup,
James Hanley <=