Re: [Qemu-devel] [PATCH v2 1/1] cadence_uart: Check baud rate generator and divider values on migration

[Alistair Francis]

On Mon, Nov 7, 2016 at 4:34 PM, Alistair Francis
<address@hidden> wrote:
> The Cadence UART device emulator calculates speed by dividing the
> baud rate by a 'baud rate generator' & 'baud rate divider' value.
> The device specification defines these register values to be
> non-zero and within certain limits. Checks were recently added when
> writing to these registers but not when restoring from migration.
>
> This patch adds checks when restoring from migration to avoid divide by
> zero errors.

Ping!

Thanks,

Alistair

>
> Reported-by: Huawei PSIRT <address@hidden>
> Signed-off-by: Alistair Francis <address@hidden>
> ---
> V2:
>  - Abort the migration if the data is invalid
>
>  hw/char/cadence_uart.c | 7 +++++++
>  1 file changed, 7 insertions(+)
>
> diff --git a/hw/char/cadence_uart.c b/hw/char/cadence_uart.c
> index def34cd..9568ac6 100644
> --- a/hw/char/cadence_uart.c
> +++ b/hw/char/cadence_uart.c
> @@ -487,6 +487,13 @@ static int cadence_uart_post_load(void *opaque, int 
> version_id)
>  {
>      CadenceUARTState *s = opaque;
>
> +    /* Ensure these two aren't invalid numbers */
> +    if (s->r[R_BRGR] <= 1 || s->r[R_BRGR] & 0xFFFF ||
> +        s->r[R_BDIV] <= 3 || s->r[R_BDIV] & 0xFF) {
> +        /* Value is invalid, abort */
> +        return 1;
> +    }
> +
>      uart_parameters_setup(s);
>      uart_update_status(s);
>      return 0;
> --
> 2.7.4
>