Re: [Qemu-devel] [PATCH v6 1/3] target-mips: Misaligned memory accesses for R6

[Leon Alrae]

On 27/05/2015 14:29, Yongbok Kim wrote:
> @@ -2143,7 +2146,8 @@ static void gen_ld(DisasContext *ctx, uint32_t opc,
>          t1 = tcg_const_tl(pc_relative_pc(ctx));
>          gen_op_addr_add(ctx, t0, t0, t1);
>          tcg_temp_free(t1);
> -        tcg_gen_qemu_ld_tl(t0, t0, ctx->mem_idx, MO_TEQ);
> +        tcg_gen_qemu_ld_tl(t0, t0, ctx->mem_idx, MO_TEQ |
> +                           ctx->default_tcg_memop_mask);
>          gen_store_gpr(t0, rt);
>          opn = "ldpc";
>          break;
> @@ -2152,22 +2156,26 @@ static void gen_ld(DisasContext *ctx, uint32_t opc,
>          t1 = tcg_const_tl(pc_relative_pc(ctx));
>          gen_op_addr_add(ctx, t0, t0, t1);
>          tcg_temp_free(t1);
> -        tcg_gen_qemu_ld_tl(t0, t0, ctx->mem_idx, MO_TESL);
> +        tcg_gen_qemu_ld_tl(t0, t0, ctx->mem_idx, MO_TESL |
> +                           ctx->default_tcg_memop_mask);
>          gen_store_gpr(t0, rt);
>          opn = "lwpc";
>          break;

As I can see in other places you skipped load/store instructions not
present in R6 spec (like pre-R6 DSP or microMIPS loads/stores), which
probably is fine. However, IIUC these two instructions LWPC and LDPC are
from mips16 ASE, so probably you want to skip them as well? (note that
for R6 we’ve got R6_OPC_LWPC and R6_OPC_LDPC and they are naturally
aligned).

Apart from that,

Reviewed-by: Leon Alrae <address@hidden>

BTW these OPC_LWPC and OPC_LDPC are very confusing... I presume these
fake instructions were created in order to reuse gen_ldst() function for
mips16 M16_OPC_LWPC and I64_LDPC instructions. It would be nice to clean
this up at some point (the same as OPC_JALRC).

Leon