qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [PATCH v5 0/7] ARM: add PSCI 0.2 support in TCG mode


From: Ard Biesheuvel
Subject: Re: [Qemu-devel] [PATCH v5 0/7] ARM: add PSCI 0.2 support in TCG mode
Date: Fri, 10 Oct 2014 12:42:37 +0200

On 9 October 2014 16:30, Peter Maydell <address@hidden> wrote:
> This series adds PSCI support to ARM and AArch64 system emulation
> when running in TCG mode. It's an update of the patchsent Ard
> sent out earlier in September which in turn is based on work
> by Rob Herring.
>
> Changes v5->v6:
>  * minor rebasing
>  * redid the way that PSCI is plumbed into SMC/HVC handling,
>    to fit into the support for EL2/EL3 which has landed since
>    v5. In particular we now test for whether this is a PSCI
>    call as a separate step from actually doing the call, since
>    we want to prefer doing PSCI to UNDEF, but UNDEF will happen
>    first if it happens at all.
>
> NB: this works for the virt board for both 32 bit and 64 bit
> CPUs. There is one bug I've seen where if you have an SMP
> configuration of 32 bit CPUs and do a guest reset then the
> guest misbehaves (segfaults, etc) after the reboot when it
> gets up to userspace. I'm not sure if this is the fault of
> these patches or just a revealed bug, so I'm sending them
> out for review anyway and will investigate further...
>

Hello Peter,

Thanks for picking this up while I was away. I have tested your
version of the series, and my test cases still appear to work
correctly.
However, we still haven't addressed the CPU reset case, so issuing the
PSCI reset under -bios does nothing.

Latest is here
http://marc.info/?l=qemu-devel&m=140993015009810&w=2

-- 
Ard.


> Ard Biesheuvel (1):
>   target-arm: add missing PSCI constants needed for PSCI emulation
>
> Peter Maydell (2):
>   target-arm: Handle SMC/HVC undef-if-no-ELx in pre_* helpers
>   target-arm: Add support for A32 and T32 HVC and SMC insns
>
> Rob Herring (4):
>   target-arm: add powered off cpu state
>   target-arm: do not set do_interrupt handlers for ARM and AArch64 user
>     modes
>   target-arm: add emulation of PSCI calls for system emulation
>   arm/virt: enable PSCI emulation support for system emulation
>
>  hw/arm/virt.c              |  82 +++++++--------
>  target-arm/Makefile.objs   |   1 +
>  target-arm/cpu-qom.h       |   7 ++
>  target-arm/cpu.c           |  20 +++-
>  target-arm/cpu.h           |   6 ++
>  target-arm/cpu64.c         |   2 +
>  target-arm/helper-a64.c    |   9 ++
>  target-arm/helper.c        |  11 ++-
>  target-arm/internals.h     |  22 +++++
>  target-arm/kvm-consts.h    |  40 ++++++++
>  target-arm/machine.c       |   5 +-
>  target-arm/op_helper.c     |  33 +++++--
>  target-arm/psci.c          | 242 
> +++++++++++++++++++++++++++++++++++++++++++++
>  target-arm/translate-a64.c |   4 +-
>  target-arm/translate.c     | 103 ++++++++++++++++---
>  target-arm/translate.h     |   2 +
>  16 files changed, 513 insertions(+), 76 deletions(-)
>  create mode 100644 target-arm/psci.c
>
> --
> 1.9.1
>



reply via email to

[Prev in Thread] Current Thread [Next in Thread]