qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [RFC PATCH 09/10] spapr_pci_vfio: Enable DDW


From: Alexey Kardashevskiy
Subject: Re: [Qemu-devel] [RFC PATCH 09/10] spapr_pci_vfio: Enable DDW
Date: Wed, 13 Aug 2014 01:10:39 +1000
User-agent: Mozilla/5.0 (X11; Linux i686 on x86_64; rv:31.0) Gecko/20100101 Thunderbird/31.0

On 08/12/2014 07:37 PM, Alexander Graf wrote:
> 
> On 12.08.14 02:03, Alexey Kardashevskiy wrote:
>> On 08/12/2014 03:30 AM, Alexander Graf wrote:
>>> On 11.08.14 17:01, Alexey Kardashevskiy wrote:
>>>> On 08/11/2014 10:02 PM, Alexander Graf wrote:
>>>>> On 31.07.14 11:34, Alexey Kardashevskiy wrote:
>>>>>> This implements DDW for VFIO. Host kernel support is required for this.
>>>>>>
>>>>>> Signed-off-by: Alexey Kardashevskiy <address@hidden>
>>>>>> ---
>>>>>>     hw/ppc/spapr_pci_vfio.c | 75
>>>>>> +++++++++++++++++++++++++++++++++++++++++++++++++
>>>>>>     1 file changed, 75 insertions(+)
>>>>>>
>>>>>> diff --git a/hw/ppc/spapr_pci_vfio.c b/hw/ppc/spapr_pci_vfio.c
>>>>>> index d3bddf2..dc443e2 100644
>>>>>> --- a/hw/ppc/spapr_pci_vfio.c
>>>>>> +++ b/hw/ppc/spapr_pci_vfio.c
>>>>>> @@ -69,6 +69,77 @@ static void
>>>>>> spapr_phb_vfio_finish_realize(sPAPRPHBState *sphb, Error **errp)
>>>>>>         /* Register default 32bit DMA window */
>>>>>>         memory_region_add_subregion(&sphb->iommu_root, tcet->bus_offset,
>>>>>>                                     spapr_tce_get_iommu(tcet));
>>>>>> +
>>>>>> +    sphb->ddw_supported = !!(info.flags &
>>>>>> VFIO_IOMMU_SPAPR_TCE_FLAG_DDW);
>>>>>> +}
>>>>>> +
>>>>>> +static int spapr_pci_vfio_ddw_query(sPAPRPHBState *sphb,
>>>>>> +                                    uint32_t *windows_available,
>>>>>> +                                    uint32_t *page_size_mask)
>>>>>> +{
>>>>>> +    sPAPRPHBVFIOState *svphb = SPAPR_PCI_VFIO_HOST_BRIDGE(sphb);
>>>>>> +    struct vfio_iommu_spapr_tce_query query = { .argsz =
>>>>>> sizeof(query) };
>>>>>> +    int ret;
>>>>>> +
>>>>>> +    ret = vfio_container_ioctl(&sphb->iommu_as, svphb->iommugroupid,
>>>>>> +                               VFIO_IOMMU_SPAPR_TCE_QUERY, &query);
>>>>>> +    if (ret) {
>>>>>> +        return ret;
>>>>>> +    }
>>>>>> +
>>>>>> +    *windows_available = query.windows_available;
>>>>>> +    *page_size_mask = query.page_size_mask;
>>>>>> +
>>>>>> +    return ret;
>>>>>> +}
>>>>>> +
>>>>>> +static int spapr_pci_vfio_ddw_create(sPAPRPHBState *sphb, uint32_t
>>>>>> page_shift,
>>>>>> +                                     uint32_t window_shift, uint32_t
>>>>>> liobn,
>>>>>> +                                     sPAPRTCETable **ptcet)
>>>>>> +{
>>>>>> +    sPAPRPHBVFIOState *svphb = SPAPR_PCI_VFIO_HOST_BRIDGE(sphb);
>>>>>> +    struct vfio_iommu_spapr_tce_create create = {
>>>>>> +        .argsz = sizeof(create),
>>>>>> +        .page_shift = page_shift,
>>>>>> +        .window_shift = window_shift,
>>>>>> +        .start_addr = 0
>>>>>> +    };
>>>>>> +    int ret;
>>>>>> +
>>>>>> +    ret = vfio_container_ioctl(&sphb->iommu_as, svphb->iommugroupid,
>>>>>> +                               VFIO_IOMMU_SPAPR_TCE_CREATE, &create);
>>>>>> +    if (ret) {
>>>>>> +        return ret;
>>>>>> +    }
>>>>>> +
>>>>>> +    *ptcet = spapr_tce_new_table(DEVICE(sphb), liobn,
>>>>>> create.start_addr,
>>>>>> +                                 page_shift, 1 << (window_shift -
>>>>>> page_shift),
>>>>> I spot a 1 without ULL again - this time it might work out ok, but please
>>>>> just always use ULL when you pass around addresses.
>>>> My bad. I keep forgetting this, I'll adjust my own checkpatch.py :)
>>>>
>>>>
>>>>> Please walk me though the abstraction levels on what each page size
>>>>> honoration means. If I use THP, what page size granularity can I use for
>>>>> TCE entries?
>>>> [RFC PATCH 06/10] spapr_rtas: Add Dynamic DMA windows (DDW) RTAS calls
>>>> support
>>>>
>>>> +        const struct { int shift; uint32_t mask; } masks[] = {
>>>> +            { 12, DDW_PGSIZE_4K },
>>>> +            { 16, DDW_PGSIZE_64K },
>>>> +            { 24, DDW_PGSIZE_16M },
>>>> +            { 25, DDW_PGSIZE_32M },
>>>> +            { 26, DDW_PGSIZE_64M },
>>>> +            { 27, DDW_PGSIZE_128M },
>>>> +            { 28, DDW_PGSIZE_256M },
>>>> +            { 34, DDW_PGSIZE_16G },
>>>> +        };
>>>>
>>>>
>>>> Supported page sizes are returned by the host kernel via "query". For 16MB
>>>> pages, page shift will return DDW_PGSIZE_4K|DDW_PGSIZE_64K|DDW_PGSIZE_16M.
>>>> Or I did not understand the question...
>>> Why do we care about the sizes? Anything bigger than what we support should
>>> always work, no? What happens if the guest creates a 16MB map but my pages
>>> are 4kb mapped? Wouldn't the same logic be able to deal with 16G pages?
>> It is DMA memory, if I split "virtual" 16M page to a bunch of real 4K
>> pages, I have to make sure these 16M are continuous - there will be one TCE
>> entry for it and no more translations besides IOMMU. What do I miss now?
> 
> Who does the shadow translation where? Does it exist at all?

IOMMU? I am not sure I am following you... This IOMMU will look as direct
DMA for the guest but the real IOMMU table is sparse and it is populated
via a bunch of H_PUT_TCE calls as the default small window.

There is a direct mapping in the host called "bypass window" but it is not
used here as sPAPR does not define that for paravirtualization.


-- 
Alexey



reply via email to

[Prev in Thread] Current Thread [Next in Thread]