qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [PATCH RFC 1/8] virtio: add subsections to the migratio


From: Amit Shah
Subject: Re: [Qemu-devel] [PATCH RFC 1/8] virtio: add subsections to the migration stream
Date: Thu, 15 May 2014 12:16:35 +0530

On (Thu) 15 May 2014 [09:23:51], Michael S. Tsirkin wrote:
> On Thu, May 15, 2014 at 11:34:25AM +0530, Amit Shah wrote:
> > On (Wed) 14 May 2014 [17:41:38], Greg Kurz wrote:
> > > There is a need to add some more fields to VirtIODevice that should be
> > > migrated (broken status, endianness). The problem is that we do not
> > > want to break compatibility while adding a new feature... This issue has
> > > been addressed in the generic VMState code with the use of optional
> > > subsections. As a *temporary* alternative to port the whole virtio
> > > migration code to VMState, this patch mimics a similar subsectionning
> > > ability for virtio.

BTW Greg, do you plan on working on vmstate for virtio?

> > > Since each virtio device is streamed in its own section, the idea is to
> > > stream subsections between the end of the device section and the start
> > > of the next sections. This allows an older QEMU to complain and exit
> > > when fed with subsections:
> > > 
> > > Unknown savevm section type 5
> > > Error -22 while loading VM state
> > 
> > Please make this configurable -- either via configure or device
> > properties.  That avoids having to break existing configurations that
> > work without this patch.
> > 
> > > All users of virtio_load()/virtio_save() need to be patched because the
> > > subsections are streamed AFTER the device itself.
> > 
> > Since all have the same fixup, I'm wondering if a new section can be
> > added to the virtio-bus itself, which gets propagated to all devices
> > upon load in the dest.
> 
> This calls for a way for devices to inherit properties from the bus,
> which doesn't exist ATM.
> Fine but let's not hold up this patchset because of this.

No, only suggestion is to add a migration section in the bus, and then
it's easier to do this in the post-migrate functions for each device
-- so only one new section gets introduced instead of all devices
being modified to send a new subsection.

                Amit



reply via email to

[Prev in Thread] Current Thread [Next in Thread]