[Qemu-devel] [PATCH] migration: Fix rate limit

[Matthew Garrett]

The migration thread appears to want to allow writeout to occur at full
speed rather than being rate limited during completion of state saving,
but sets the limit to INT_MAX when xfer_limit is INT64_MAX. This causes
problems if there's more than 2GB of state left to save at this point. It
probably ought to just be INT64_MAX instead.

Signed-off-by: Matthew Garrett <address@hidden>
---
 migration.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/migration.c b/migration.c
index 2b1ab20..ff00bfb 100644
--- a/migration.c
+++ b/migration.c
@@ -583,7 +583,7 @@ static void *migration_thread(void *opaque)
 
                 ret = vm_stop_force_state(RUN_STATE_FINISH_MIGRATE);
                 if (ret >= 0) {
-                    qemu_file_set_rate_limit(s->file, INT_MAX);
+                    qemu_file_set_rate_limit(s->file, INT64_MAX);
                     qemu_savevm_state_complete(s->file);
                 }
                 qemu_mutex_unlock_iothread();
-- 
1.8.4.2