Re: [Qemu-devel] hw/Makefile.objs question

[Andreas Färber]

Am 21.06.2012 05:22, schrieb Alexey Kardashevskiy:
> I am trying to compile the very last qemu with vfio_pci enabled. VFIO_PCI is 
> added as below:
> 
> ./configure:
> 
>  case "$target_arch2" in
>   i386|x86_64|ppc64)
>      if test "$vfio_pci" = "yes" -a "$target_softmmu" = "yes" ; then
>        echo "CONFIG_VFIO_PCI=y" >> $config_target_mak
>      fi
>  esac
> 
> 
> ./Makefile.target:
> 
>  # VFIO PCI device assignment
> obj-$(CONFIG_VFIO_PCI) += vfio_pci.o
> 
> 
> And it worked before. However it does not anymore as it seems that everything 
> in hw/ (and vfio_pci.c
> as well as is in hw/ and it is a device) can be only compiled via 
> hw/Makefile.objs and
> hw/ppc/Makefile.objs (my platform is POWER), it is ignored if to keep it as 
> is.
> 
> So I have to move "obj-$(CONFIG_VFIO_PCI) += vfio_pci.o" to hw/Makefile.objs 
> (and change obj- to
> hw-obj-) but the hw/Makefile.objs does not include (directly or indirectly) 
> generated
> ppc64-softmmu/config-target.mak with CONFIG_VFIO_PCI=y.
> 
> What is the correct solution?

If the file compiles the same for all three, put CONFIG_VFIO_PCI=y into
default-configs/{i386,x86_64,ppc64}-softmmu.mak and do
hw-obj-$(CONFIG_VFIO_PCI) += in hw/Makefile.objs.

Otherwise, add to hw/{i386,ppc}/Makefile.objs - or with Anthony's
proposal from yesterday hw/Makefile.objs becomes possible, too.

Andreas

-- 
SUSE LINUX Products GmbH, Maxfeldstr. 5, 90409 Nürnberg, Germany
GF: Jeff Hawn, Jennifer Guild, Felix Imendörffer; HRB 16746 AG Nürnberg