Re: [Qemu-devel] [PATCH 1/4] SPARC64: Implement ldfa/lddfa/ldqfa instructions properly

[tsnsaito]

Hi,

At Wed, 13 Jul 2011 21:19:16 +0300,
Blue Swirl wrote:
> On Wed, Jul 13, 2011 at 9:02 PM, Artyom Tarasenko <address@hidden> wrote:
> > On Wed, Jul 13, 2011 at 6:27 PM, Blue Swirl <address@hidden> wrote:
> >> On Wed, Jul 13, 2011 at 6:30 AM, Tsuneo Saito <address@hidden> wrote:
> >>So you should perform some arithmetic with
> >> the ASI numbers to make them match non-block ASIs, for example asi &
> >> ~0x6. This only works in the specific block ASIs, so I'd move this
> >> inside the switch block for cases 0x16, 0x17, 0x1e, 0x1f etc. By the
> >> way, aren't those the ASIs in question? The manual (UltraSPARC
> >> Architecture 2007) is a bit confusing.

Thanks for the review!
I didn't know these ASIs (0x16, 0x17, 0x1e, 0x1f) as I was looking
at the JPS 1.0.4 specification.  I'll add codes for these ASIs.

---- 
Tsuneo Saito <address@hidden>