[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] Sparc emulation no longer boots
From: |
Nigel Horne |
Subject: |
Re: [Qemu-devel] Sparc emulation no longer boots |
Date: |
Mon, 10 Aug 2009 11:23:47 +0100 |
User-agent: |
Mozilla-Thunderbird 2.0.0.22 (X11/20090701) |
Here's some more information.
Using the same disc image, but with an older version of qemu, the guest
Linux boots:
...
umount[11]: Unimplemented SPARC system call 188
cat[12]: Unimplemented SPARC system call 188
SCSI subsystem driver Revision: 1.00
esp0: IRQ 36 SCSI ID 7 Clk 40MHz CCYC=25000 CCF=8 TOut 167 NCR53C90(esp100)
ESP: Total of 1 ESP hosts found, 1 actually in use.
scsi0 : Sparc ESP100 (NCR53C90)
Vendor: QEMU Model: QEMU HARDDISK Rev: 0.9.
Type: Direct-Access ANSI SCSI revision: 03
Vendor: QEMU Model: QEMU CD-ROM Rev: 0.9.
Type: CD-ROM ANSI SCSI revision: 03
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 4194304 512-byte hdwr sectors (2147 MB)
Partition check:
/dev/scsi/host0/bus0/target0/lun0: p1 p2 p3 p4
Journalled Block Device driver loaded
Compare this with the looping version in git:
....
initrd-tools: 0.1.84.2
umount[11]: Unimplemented SPARC system call 188
cat[12]: Unimplemented SPARC system call 188
Then qemu loops.
Perhaps the problem lies within the SCSI emulation?
-Nigel