Re: [Qemu-devel] [PATCH 1/3] PPC4xx IIC and MAL

[Hollis Blanchard]

On Tue, 2008-12-09 at 01:46 +0000, Salvatore Lionetti wrote:
> Hi
> 
> This set of patch try to full support hw present in 'walnut' board.
> http://elinux.org/DHT-Walnut
> 
> The fw used to successfully verify board is u-boot-1.3.4.
> 
> The only component not tested is PCI: perhaps should be a good start
> point for Hollis 's recent work, which i thanks for previous code
> review.
> 
> 1) IIC: new eeprom device, full emulation of 4xx master core 
>    MAL: Moved interface so can be shared with other modules
>    4xx boards: move MAL & IIC common part between ppc4xx cpu
>                add a list of created devices, so machine 2 phase
> creation is allowed,
> 
>    Warning: to compile:
>    - comment line 'ppc4xx_emac_init(...)' in module hw/ppc405_boards.c
>    - rename ppc405ep_init(args) in ppc405xp_init("405ep", args, NULL)
> 
>    Files changed:
>    - Makefile.target
>    - Makefile
>    - hw/ppc405_uc.c
>    - hw/ppc4xx_devs.c
>    - hw/ppc405.h
>    - hw/i2c.h
>    - hw/iic_eeprom.c (Added)
>    - hw/ppc4xx.h

Please split this into smaller patches which can be more easily
reviewed. For example, you should send one patch that *only* moves the
i2c code (and makes no changes). Then submit a patch that modifies the
code in its new location. You should submit separate patches for MAL and
I2C. You should not change the DEBUG #defines, nor add debug calls to
printf.

In other words, please remove all extraneous changes from your patch,
and break it up into small self-contained pieces that can be committed
one by one.

-- 
Hollis Blanchard
IBM Linux Technology Center