[Qemu-devel] [patch 3/4] Improve pflash cfi01 debug messages

[Thomas Petazzoni]

This patches slightly improves the debugging messages in pflash_read()
and pflash_write().

Signed-off-by: Thomas Petazzoni <address@hidden>
---
 hw/pflash_cfi01.c |    6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

Index: qemu/hw/pflash_cfi01.c
===================================================================
--- qemu.orig/hw/pflash_cfi01.c
+++ qemu/hw/pflash_cfi01.c
@@ -111,8 +111,8 @@
     else if (pfl->width == 4)
         boff = boff >> 2;
 
-    DPRINTF("%s: reading offset " TARGET_FMT_lx " under cmd %02x\n",
-            __func__, boff, pfl->cmd);
+    DPRINTF("%s: reading offset " TARGET_FMT_lx " under cmd %02x width %d\n",
+            __func__, offset, pfl->cmd, width);
 
     switch (pfl->cmd) {
     case 0x00:
@@ -205,7 +205,7 @@
     cmd = value;
     offset -= pfl->base;
 
-    DPRINTF("%s: offset " TARGET_FMT_lx " %08x %d wcycle 0x%x\n",
+    DPRINTF("%s: writing offset " TARGET_FMT_lx " value %08x width %d wcycle 
0x%x\n",
             __func__, offset, value, width, pfl->wcycle);
 
     /* Set the device in I/O access mode */

-- 
Thomas Petazzoni, Free Electrons
Kernel, drivers and embedded Linux development,
consulting, training and support.
http://free-electrons.com