Hi,
I’m trying to get Juniper software running on
QEMU. I’ve managed to get it installed and operational however I
can’t setup a network interface as the software is very specific about
the type of network card it will accept. In vmware you can do the following to
have it emulate an intel adaptor ethernet0.virtualDev = "e1000", which shows up as an em interface under freeBSD.
Is there any support for this with QEMU?
Regards Jeff
This communication, including any attachments, is confidential. If you are not the intended recipient, you should not read it - please contact me immediately, destroy it, and do not copy or use any part of this communication or disclose anything about it. Thank you. Please note that this communication does not designate an information system for the purposes of the Electronic Transactions Act 2002.
|