[PULL 28/56] hw/block/nvme: Correct error status for unaligned ZA

[Klaus Jensen]

From: Dmitry Fomichev <dmitry.fomichev@wdc.com>

TP 4053 says (in section 2.3.1.1) -
... if a Zone Append command specifies a ZSLBA that is not the lowest
logical block address in that zone, then the controller shall abort
that command with a status code of Invalid Field In Command.

In the code, Zone Invalid Write is returned instead, fix this.

Signed-off-by: Dmitry Fomichev <dmitry.fomichev@wdc.com>
Signed-off-by: Klaus Jensen <k.jensen@samsung.com>
---
 hw/block/nvme.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/hw/block/nvme.c b/hw/block/nvme.c
index c73afdf8054f..35f39ecd9559 100644
--- a/hw/block/nvme.c
+++ b/hw/block/nvme.c
@@ -1150,7 +1150,7 @@ static uint16_t nvme_check_zone_write(NvmeCtrl *n, 
NvmeNamespace *ns,
         if (append) {
             if (unlikely(slba != zone->d.zslba)) {
                 trace_pci_nvme_err_append_not_at_start(slba, zone->d.zslba);
-                status = NVME_ZONE_INVALID_WRITE;
+                status = NVME_INVALID_FIELD;
             }
             if (nvme_l2b(ns, nlb) > (n->page_size << n->zasl)) {
                 trace_pci_nvme_err_append_too_large(slba, nlb, n->zasl);
-- 
2.30.0