qemu-arm
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[PULL 1/3] hw: Only compile the usb-dwc2 controller if it is really need


From: Gerd Hoffmann
Subject: [PULL 1/3] hw: Only compile the usb-dwc2 controller if it is really needed
Date: Fri, 24 Jul 2020 18:42:56 +0200

From: Thomas Huth <thuth@redhat.com>

The USB_DWC2 switch is currently "default y", so it is included in all
qemu-system-* builds, even if it is not needed. Even worse, it does a
"select USB", so USB devices are now showing up as available on targets
that do not support USB at all. This sysbus device should only be
included by the boards that need it, i.e. by the Raspi machines.

Fixes: 153ef1662c ("dwc-hsotg (dwc2) USB host controller emulation")
Signed-off-by: Thomas Huth <thuth@redhat.com>
Reviewed-by: Paul Zimmerman <pauldzim@gmail.com>
Message-id: 20200722154719.10130-1-thuth@redhat.com
Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
---
 hw/arm/Kconfig | 1 +
 hw/usb/Kconfig | 1 -
 2 files changed, 1 insertion(+), 1 deletion(-)

diff --git a/hw/arm/Kconfig b/hw/arm/Kconfig
index 4a224a6351ab..bc3a423940b7 100644
--- a/hw/arm/Kconfig
+++ b/hw/arm/Kconfig
@@ -315,6 +315,7 @@ config RASPI
     select FRAMEBUFFER
     select PL011 # UART
     select SDHCI
+    select USB_DWC2
 
 config STM32F205_SOC
     bool
diff --git a/hw/usb/Kconfig b/hw/usb/Kconfig
index d4d8c37c2897..5e63dc75f815 100644
--- a/hw/usb/Kconfig
+++ b/hw/usb/Kconfig
@@ -48,7 +48,6 @@ config USB_MUSB
 
 config USB_DWC2
     bool
-    default y
     select USB
 
 config TUSB6010
-- 
2.18.4




reply via email to

[Prev in Thread] Current Thread [Next in Thread]