[Qemu-arm] [PATCH v4] numa: improve cpu hotplug error message with a wrong node-id

[Laurent Vivier]

On pseries, core-ids are strongly binded to a node-id by the command
line option. If an user tries to add a CPU to the wrong node, he has
an error but it is not really helpful:

  qemu-system-ppc64 ... -smp 1,maxcpus=64,cores=1,threads=1,sockets=1 \
                        -numa node,nodeid=0 -numa node,nodeid=1 ...

  (qemu) device_add power9_v2.0-spapr-cpu-core,core-id=30,node-id=1
  Error: node-id=1 must match numa node specified with -numa option

This patch improves this error message by giving to the user the good
node-id to use with the core-id he's providing

  Error: invalid node-id, must be 0

Signed-off-by: Laurent Vivier <address@hidden>
---

Notes:
    v4: simplify the message
    
    v3: only add the topology to the existing message
        As suggested by Igor replace
          Error: core-id 30 can only be plugged into node-id 0
        by
          Error: node-id=1 must match numa node specified with -numa option 
'node-id 0'
    
    v2: display full topology in the error message

 numa.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/numa.c b/numa.c
index 3875e1efda3a..955ec0c830db 100644
--- a/numa.c
+++ b/numa.c
@@ -470,8 +470,8 @@ void numa_cpu_pre_plug(const CPUArchId *slot, DeviceState 
*dev, Error **errp)
                                     "node-id", errp);
         }
     } else if (node_id != slot->props.node_id) {
-        error_setg(errp, "node-id=%d must match numa node specified "
-                   "with -numa option", node_id);
+        error_setg(errp, "invalid node-id, must be %"PRId64,
+                   slot->props.node_id);
     }
 }
 
-- 
2.20.1