Re: [Partysip-dev] IPv6

[Anthony Liu]

Hi,

As a supplement. Yes, it is partysip6.conf. This is because IPv6 and
IPv4 are not supported at the same time and if you want to switch 
over between them, you will need not worry about the config file been
over written.

Anthony

在 週二, 2003-06-03 17:34, Aymeric Moizard 寫道：
> 
> You have to compile partysip with the following command:
> CFLAGS="-DIPV6_SUPPORT" ./configure
> make
> make install
> 
> If I remmember, the correct config file name will be partysip6.conf
> Aymeric
> 
> On Tue, 3 Jun 2003, Leva wrote:
> 
> > Hi all,
> >
> >
> > Now almost all exams is over, I want to test partysip in a IPv6 cloud. How 
> > to
> > compile partysip to have IPv6 support? I have 0.6.0. It does not accept any
> > IPv6 address in the ServerIP field.
> >
> > Thanx: Leva
> >
> > __
> >
> > E-Mail: address@hidden
> > AIM: ha5ogl
> > ICQ: 48710903
> > MSN: address@hidden
> > Yahoo!: kieg_tk16
> > Home Page: http://web.interware.hu/leva
> > Public key: http://web.interware.hu/leva/cuccok/public_key
> >
> > ________________________________________
> >
> > /"\
> > \ /    ASCII Ribbon Campaign
> >  X   against HTML email & vCards
> > / \     http://arc.pasp.de/
> >
> > Have Fun, & Linux! 73 for all by HA5OGL.
> > This message was generated by Sylpheed.
> >
> >
> > _______________________________________________
> > Partysip-dev mailing list
> > address@hidden
> > http://mail.nongnu.org/mailman/listinfo/partysip-dev
> >
> 
> 
> 
> _______________________________________________
> Partysip-dev mailing list
> address@hidden
> http://mail.nongnu.org/mailman/listinfo/partysip-dev