Re: [Paparazzi-devel] Have anyone successfully combine paparazzi uav with the qgroundcontrol ?

[Prof. Dr.-Ing. Heinrich Warmers]

Hi,
sometimes the motor current wires  or  the battery
wires  are to near to the magnet sensor (keep it 6-10cm away).
If you use a switch wire the plus and minus wire to the switch.
Twist all wires.
Often it helps to use a double side PCB for current allocation.

Make this brutal test:
Hold the copter on the ground  and give  full  throttle to all motors.
Under this condition the magnetic direction  must have not more then 
5°declination.
Sometimes it is a hard way to get good results.






Am 14.03.2016 09:38, schrieb wang siqi:
> Hi all,
>      Does anyone apply the qgroundcontrol on the paparazzi uav successfully?
> If so, could you tell my the way ? (the imu calibration is too difficult for
> me to use, I have tried several times to calibrate the magnetometer,
> however, my quadrotor still has the tendency to rotate by itself when taking
> off...) Any help would be appreciated!
>
>
>
> --
> View this message in context: 
> http://lists.paparazziuav.org/Have-anyone-successfully-combine-paparazzi-uav-with-the-qgroundcontrol-tp17775.html
> Sent from the paparazzi-devel mailing list archive at Nabble.com.
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel