Re: [Paparazzi-devel] Rudder Trim Problems

[Meghan]

Thank you SilaS. 

On the radio control wiki page, it does not talk about end points. I calibrated 
my radio ppm values with the end points set in my Tx to limit the servo throw. 
Is there a better way of doing this?

Meghan

On Aug 18, 2015, at 12:36 PM, SilaS <address@hidden> wrote:

> 
> Hi,
> 
> Check you radio config file! It is possible that it was created without 110% 
> EPA and therefore when You made trims it makes confusion for ppm decoder.
> Try to made your own radio config as it described on the wiki.
> 
> SilaS
> 
> 2015-08-18 19:32 keltezéssel, Meghan írta:
>> We are using Lisa/M 2.1 and a futaba T10CAP Tx. All of the servos work in 
>> both manual and auto1 without trim. When I add a +4 rudder trim on the Tx, 
>> told the rudder stick to the right, I lose all control to the rest of the 
>> servos including the motor. If I pull the rudder in the other direction with 
>> the +4 rudder trim, all servos work. When I add a -4 rudder trim, all of the 
>> servos work when the rudder is pulled both left and right.
>> 
>> Even though we may not need to trim the rudder in flight, I think this may 
>> lead to other problems. Last time we flew, we had aileron trim and the 
>> elevators gave out on takeoff in manual mode, but control was gained after a 
>> couple seconds. I have not been able to achieve the same results with the 
>> aileron trim on the ground, but definitely have consistent servo problems 
>> when rudder rudder trim is added.
>> 
>> Does anyone have any idea what may be causing this?
>> 
>> Thanks,
>> Meghan
>> _______________________________________________
>> Paparazzi-devel mailing list
>> address@hidden
>> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
> 
> 
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel