Re: [Paparazzi-devel] Powering Lisa/M

[Marius Pfeffer]

Hello

If you use a battery with more than 3 cells the voltage divider has the wrong resistor values. (if you connect a battery with more cells direct you would go over the maximum voltage of that pin)

Take a look at the Lisa/m wiki page.

You need to change the resistors of the voltage divider.

-Marius

Am 22.05.2014 14:58 schrieb "Joey" <address@hidden>:

Hi all,

I read that I cannot use a battery with more than 3 cells if I want to
measure the voltage with the V_BAT pin on the I2C. However, the motors that
I want to use need a battery with more than 3 cells. Is there a way to
connect a battery with more than 3 cells?

Thanks

Joey



--
View this message in context: http://lists.paparazziuav.org/Powering-Lisa-M-tp15519.html
Sent from the paparazzi-devel mailing list archive at Nabble.com.

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel