Re: [Paparazzi-devel] how to disable failsafe in orange openlrs 433Mhz receiver

[Gerard Toonstra]

The Orange saves a failsafe position, correct?

You can distinguish failsafes by increasing tx range to -125% or less on throttle, such that the throttle value is something under 1000us. 
This is then set as failsafe. Then decrease the range to the normal -100%. When you set throttle to zero, it works as normal. 

When you turn the radio off, the failsafe value is sent, which then triggers the AP for RC lost condition, assuming you have it configured correctly there.

G>

On Tue, Jul 23, 2013 at 7:46 PM, Refik Sever <address@hidden> wrote:

Dear all,

We are using orange openLRS 433 MHz Tx and Rx module with ER9x transmitter. We also use 8ch ppm encoder. When we switch off the transmitter power, the receiver goes into failsafe. Therefore, the autopilot does not understand that RC is lost.

Does anybody know how to disable failsafe in this receiver?

Regards,
Refik

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel