[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Paparazzi-devel] Eagle Tree Airspeed Sensor Problem
From: |
Jorge Pantoja |
Subject: |
[Paparazzi-devel] Eagle Tree Airspeed Sensor Problem |
Date: |
Fri, 14 Jun 2013 00:12:34 -0500 |
Hello all,
I am trying to put to work the Eagle Tree airspeed sensor on a YAPA2 connected
to the I2C port as described on the wiki. Every time I turn on the autopilot
and then power the eagle tree sensor my autopilot freezes (the LEDs on the
autopilot board stop blinking), I can see that I only get error packages on the
telemetry link and my Ground Station stops receiving information.
I have connected the sensor as described on the wiki (GND to white, +5V to Red,
SDA to Yellow and SCL to brown). To power the sensor I connected the Red cable
to one of the +5V ports used to power the servos and I also tried connecting it
directly to the 14V battery that I am using to power the YAPA2 with the same
results.
Anyone has any thoughts?
Best Regards,
Jorge
- [Paparazzi-devel] Eagle Tree Airspeed Sensor Problem,
Jorge Pantoja <=