[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Paparazzi-devel] hardware and software development Servo_counter
From: |
Heinrich Warmers |
Subject: |
Re: [Paparazzi-devel] hardware and software development Servo_counter |
Date: |
Tue, 07 Aug 2012 17:00:44 +0200 |
User-agent: |
Mozilla/5.0 (Windows; U; Windows NT 5.1; de-DE; rv:1.4) Gecko/20030619 Netscape/7.1 (ax) |
Hi,
one question for the NAVGO v3,
is it possible to add 2 pins SERV_RST (pin 48 ) SERV_CLK (pin29) to a
connector or to make solder pads for it?
Then this nice autopilot is then able to fly normal wing configuration
or multicopter with low cost motor controller (larger device > 40cm)
with a separate servo connector pcb shown in the appendix. This pcb is
made to solder 2.54 mm connector strips direct for normal servo connectors.
Heinrich
Gautier Hattenberger schrieb:
Hello Sergey and other hw/sw developers,
When you have developed new hardware (autopilots, expansion boards,
sensor boards...) or software (driver, new feature,...), do not
hesitate to use this mailing list to announce it, send patches/links,
or even better use the github pull request service. And of course,
documentation on the wiki is always a good idea ;)
All this OSD discussion shows that people are making a lot of nice
stuff around the Paparazzi project and that even more people want to
use them! We are really willing to help more developers to share their
amazing work and contribute to this project.
If you have any questions on how to contribute, have a look at this
page: http://paparazzi.enac.fr/wiki/Contributing or contact us on this
mailing list.
Happy hacking
Gautier
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
hb_servo.pdf
Description: Adobe PDF document
hb_servo_sch.pdf
Description: Adobe PDF document