[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Paparazzi-devel] usb upload error
From: |
wang yao |
Subject: |
[Paparazzi-devel] usb upload error |
Date: |
Fri, 25 May 2012 21:45:05 +0800 |
hi all
i have lisa 2.0 assembled by myself , i use stm32F105RCT6 and a 12M crystal but i cant use the luftboot. when i change a 8M crystal and the leds runs up and down ,so i thought that was good sign.
when i flash it in paparazzi center. the error shows
No devices found!
make[1]: *** [upload] error 255
make[1]:leaving dir `/home/administrator/paparazzi/sw/airborne'
make: *** [ap.upload] error 2
make:leaving dir “/home/administrator/paparazzi”
and i type dmesg in the terminal and i can see this:
[ 129.204082] usb 5-1: new full speed USB device number 14 using uhci_hcd
[ 129.324093] usb 5-1: device descriptor read/64, error -71
[ 129.548110] usb 5-1: device descriptor read/64, error -71
[ 129.764124] usb 5-1: new full speed USB device number 15 using uhci_hcd
[ 129.884128] usb 5-1: device descriptor read/64, error -71
[ 130.108080] usb 5-1: device descriptor read/64, error -71
[ 130.324117] usb 5-1: new full speed USB device number 16 using uhci_hcd
[ 130.732093] usb 5-1: device not accepting address 16, error -71
[ 130.844067] usb 5-1: new full speed USB device number 17 using uhci_hcd
[ 131.252081] usb 5-1: device not accepting address 17, error -71
[ 131.252106] hub 5-0:1.0: unable to enumerate USB device on port 1
i have tried almost every thing (connect ADC2 to GND, installed the python-usb,add rules....)
so what goes wrong on the lisa board?
- [Paparazzi-devel] usb upload error,
wang yao <=