On Tue, Apr 10, 2012 at 6:36 PM, Chris Wozny
<address@hidden> wrote:
All,
Our GPS uses 3.3V input and I know that I need to change the jumper
configuration to use 3.3 instead of VIN. I just wanted to verify that
to do that I need to open JP6 and close JP7 with the same resistor.
Figured I'd check so that I don't go about connecting my VIN to 3.3V
and destroying my board :)
Thanks,
Chris
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel