[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] PPM encoder not transmitting power to the receiver

From: Luiz Flavio Felizardo
Subject: Re: [Paparazzi-devel] PPM encoder not transmitting power to the receiver
Date: Sun, 1 Apr 2012 21:10:28 -0300

I had the same problem, my solution was to get the energy needed on the receiver from a servo.
so the 5v and GND directly from a servo input to the receiver battery slot.

On Sun, Apr 1, 2012 at 8:46 PM, Jaime Rubio <address@hidden> wrote:

I am integrating the RC into my hardware and I am having the following problem: The connections between the autopilot (Yapa) and the PPM encoder work ok, but not so with the receiver. When the autopilot is powered, the PPM encoder gets that power but it is not transmitted to the receiver (i.e. multimeter reads zero voltage coming out from the output voltage pins from the PPM to the receiver).

Could anybody give us any hint to fix this?


Jaime Rubio
Autopilot Team Lead

Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]