[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] PPZ Communication Protocol

From: Felix Ruess
Subject: Re: [Paparazzi-devel] PPZ Communication Protocol
Date: Sat, 28 Jan 2012 20:24:12 +0100


the available message are defined in conf/messages.xml
conf/telemetry/default_fixedwing_imu.xml just defines which of these
messages get sent how often if you use that telemetry configuration

Have a look at

Documentation could be improved, so feel free to ask questions and
extend the wiki where needed :-)
Or even better, stuff like this should probably go to the future
paparazzi dev manual:

Cheers, Felix

On Sat, Jan 28, 2012 at 8:14 PM, Charles Breingan <address@hidden> wrote:
> Hi all,
> I am trying to write my own software ground station interface to the
> paparazzi and I am having trouble finding the messaging standard documented
> anywhere. I've looked in a bunch of places and I found the messages sets in
> the conf folder in default_fixedwing_imu.xml. This is a good start to
> figuring out the messages, but I still can't find documentation on start
> bytes, or checksums, or anything else that these messages might include.
> Does anybody know where to find this information?
> I have been watching the byte stream over my xbee and I think that I see a
> pattern. Do messages start with 0x99? That looks like a start byte to me,
> but I can't figure out what comes after that.
> Any help would be greatly appreciated. Thanks.
> Sincerely,
> C. Randy Breingan
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden

reply via email to

[Prev in Thread] Current Thread [Next in Thread]