[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Lisa PCB pool

From: Tilman Baumann
Subject: Re: [Paparazzi-devel] Lisa PCB pool
Date: Tue, 24 Jan 2012 16:27:14 +0000
User-agent: Mozilla/5.0 (X11; Linux i686; rv:9.0) Gecko/20111222 Thunderbird/9.0.1

I guess it depends if you want to sell it as a kit or pre assembled.

Eric got the PCB. I'm sure his source can churn out a few more. Boards are cheap these days.

You just need the get the parts (digikey, farnell, ...) and bag them...
We would save a bit by ordering bulk.

Of course if you want to get them assembled then you are in a heap of trouble. Then you'd have to buy the parts on reels and the fab will charge you for setting up the machines.

You'd have to sell a few boards to get those costs back in. I would suggest we think about this as plan b if we have enough interest...

Dave from has a nice section on PCP production

On 24/01/12 15:00, Gareth Roberts wrote:
Hi Simon,

The minimum my place was willing to make was 10. Someone with more experience There was a one-off tooling cost, plus a (very good) scaled volume discount for 25, 50 etc.


On Tue, 24 Jan 2012 13:41:06 -0000, Simon Wilks <address@hidden> wrote:

Hi Gareth,

What quantities would be an acceptable minimum from your experience?

reply via email to

[Prev in Thread] Current Thread [Next in Thread]