[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Lisa M wiring layout

From: Bruzzlee
Subject: Re: [Paparazzi-devel] Lisa M wiring layout
Date: Sun, 01 Jan 2012 14:43:06 +0100
User-agent: Mozilla/5.0 (Macintosh; Intel Mac OS X 10.7; rv:8.0) Gecko/20111105 Thunderbird/8.0

Thanks for the answers.

@ Eduardo
Of course I will share my tests to the community

@ Eric
Is the Lisa M usually been powered by the I2C1 CAN plug with 11.1V?
Because this looks strange to me...


Am 31.12.11 21:03, schrieb Eduardo lavratti:
Bruzzlee, i am using lisa/m too.
Please, report your tests to the group.

I have strange behavior with my copter.
Some of this caused by vibration and other that i not know the cause.


> From: address@hidden
> Date: Sun, 1 Jan 2012 01:46:19 +1030
> To: address@hidden
> Subject: Re: [Paparazzi-devel] Lisa M wiring layout
> Hi Bruzzlee
> It looks good to me and yes the ADC1 bridge is needed only for the initial bind to the Spektrum receiver (or receivers, you can use two at once)
> Eric
> On 30/12/2011, at 7:51 AM, Bruzzlee wrote:
> > Hi all
> > After a long break I've continued the work on my quadrotor Lisa M project. Now I've done my wiring layout but I'm not sure if everything is correct.
> > Especially the power source for the board: I2C1 CAN (V_BATT/GND) or SERVO1 (SV/GND)?
> > The ADC1 bridge - I need it only for the first binding to the spectrum remote - right?
> >
> > I want to publish this layout on wiki - please report mistakes!
> >
> > thx
> > Bruzzlee
> > <LisaMWiring.png>_______________________________________________
> > Paparazzi-devel mailing list
> > address@hidden
> >
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden

Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]