Note that paparazzi PPM reading is very selective. This dates from the time where everyone was using 35MHz. If 2 transmitters were on the same frequency, you wanted to be sure that paparazzi would not accept this corrupted signal.
-Christophe
On Fri, Nov 18, 2011 at 8:33 AM, Jochen Rieger
<address@hidden> wrote:
Hello,
i have a problem with the PPM at Lisa/L. I can see an signal at PPM output of the 8 Channel PPM Encoder Version 2, that seems to be a PPM signal(measured with scope). The input port of the PPM signal is the Trig. port of UART1 at Lisa/L (pin 1).
But when I set the tele_FBW to 1 in GCS. I see only 0,0,0,0,0,0 in the value message window.
I have setup the radio file like the wiki. The right pulse_type and the right numbers of input channelns.
Have anyone an idea?
Best regards.
Jochen
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel