Re: [Paparazzi-devel] Problem with Tunnel

[Felix Ruess]

Hi Oli,

please add the usb_tunnel_0 to your airframe file:
 <firmware name="setup">
   <target name="tunnel" board="twog_1.0" />
   <target name="usb_tunnel_0" board="twog_1.0" />

 </firmware>

[edit]

And pull the latest version from git, tunnels should be fixed again.

Cheers, Felix

On Thu, Dec 30, 2010 at 8:10 PM, Ensslin Oliver (enso) <address@hidden> wrote:

Hi All

I am trying to fash the USB-Tunnel onto my Tiny 2.11.

I flashed my airframe Calmato onto the Tiny and then, after restarting the Tiny into the boot loader, I tryed to << make AIRCRAFT=Calmato usb_tunnel_0.upload >> like described in the wiki under Compiling. After doing that i get all kind of errors. Mostly Error 2.

Here an Example:
<<
Using gcc-arm 3.4.4 packaged by paparazzi.
make[1]: *** Keine Regel vorhanden, um das Target »/home/oli/paparazzi_30.12.10/var/Calmato/usb_tunnel_0/usb_tunnel_0.elf«,
 benötigt von »elf«, zu erstellen.  Schluss.
make: *** [usb_tunnel_0.compile] Fehler 2
>>
In english this means as much as:
<<
Using gcc-arm 3.4.4 packaged by paparazzi.
make[1]: *** No rule available, to target »/home/oli/paparazzi_30.12.10/var/Calmato/usb_tunnel_0/usb_tunnel_0.elf«,
 needet from »elf«, to build.  end.
make: *** [usb_tunnel_0.compile] Error 2
>>

When flashing with the Paparazzi Center with the target Tunnel_0 i get the message:
<< arch/lpc21/uart_tunnel.c:6:21: init_hw.h: No such file or directory >>

Does anyone know where this error comes from??

Cheers Oli





_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel