Re: [Paparazzi-devel] XBee Pro RF to PC

[David Conger]

Hello,

Yes, you use the provided USB to Tiny1.3 cable to program it. All cables are 
provided with the bundle 12 you ordered. Plug the 10pin molex in, connect a 
mini-usb cable to the mini-usb end. Connect the USB to the Laptop. Follow the 
instructions on the Wiki. http://paparazzi.enac.fr/wiki/Compiling#USB_flashing

The FTDI Utility board has an outline of an XBee on it. Orient the XBee so it 
looks like the white outline as viewed from the top. 

You can email me directly if you wish address@hidden

Regards,
David Conger
www.ppzuav.com

On Apr 13, 2010, at 3:26 PM, Reegan M wrote:

> Hello everyone!
>  
> It has been a while since I was last in comunication. 
>  
> I have reached the stage of implementing the autopilot hardware.  Before I 
> jumped into this step I wanted to verify a few points.
>  
> I am using the Tiny 1.3 bundle from PPZUAV.  From what I understand I am able 
> to flash the Tiny directly using the USB adapte.  Is this correct?  Also it 
> seems that the connection from the the XBee Pro RF to the PC is thorugh the 
> FTDI Utility Board.  If this is so, trying to be careful and not completely 
> ignorant, which direction does the XBee plug into the FTDI?
>  
> I think that I have everything else figured out up to tis point.  Hopefully 
> if others arise I will be able to jump though those hoops.
>  
> Thanks for y'all help,
> Race
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel