paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Paparazzi-devel] power board


From: Mohammed Abukhalid
Subject: RE: [Paparazzi-devel] power board
Date: Thu, 28 Jan 2010 12:56:57 -0500

Thanks for the reply! No its just 4 motors.. I was just saying the range was 6A-14A ... and in all probability we are going to be running well below 14A. The only concern that was raised was whether the traces on the pcb could handle it. But if you've done it before with the same board then we're fine for sure

> Date: Thu, 28 Jan 2010 18:13:30 +0100
> Subject: Re: [Paparazzi-devel] power board
> From: address@hidden
> To: address@hidden
>
> the mosfet is rated 80 amps - I've made this board for my mikrokopter
> frame where the motors draw about the same current - you should be
> fine.
> or are you saying you are using 6 motors drawing each 14 amps ? in
> which case you'd be just over th limit
>
> On Thu, Jan 28, 2010 at 5:57 PM, Mohammed Abukhalid
> <address@hidden> wrote:
> > Hi all,
> >
> > I was wondering if anyone is familiar with the Booz power board design
> > enough to know its current limitations. Our motors are supposed to use 6-14A
> > of current... Anyone know if the traces on booz power board can handle that
> > much?
> >
> > Mohammed
> >
> > ________________________________
> > Spread the cheer with Messenger for mobile. Learn more.
> > _______________________________________________
> > Paparazzi-devel mailing list
> > address@hidden
> > http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
> >
> >
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel


Tell the whole story with photos, right from your Messenger window. Learn how!

reply via email to

[Prev in Thread] Current Thread [Next in Thread]