Re: [Paparazzi-devel] Booz - PPS?

[Jayson MacKiddie]

Hello Poine,

So far we have mounted:
-MCU and all components supporting it
-3.3V regulator and associated components
-USB connector and associated components

To be mounted for LED test program (as we understand)
-Bootloader molex connector
-Remaining LEDs associated 1K resistors

1) Shall we follow the same instructions given for Tiny bootloader
flashing? That was our expectation considering the hardware is the same
with regards to the bootloader connections.
2) Also We have Ubuntu running on a virtual machine. Could this pose any problems?

We would like to have the bootloader flashed very shortly. I am preparing for both bootloader flashing and LED test program upload and execution.
We would like to test the LED hello world program before populating the
other components so that we can verify functionality of the the MCU
first. 

Regards,
Jayson

On Wed, Dec 30, 2009 at 2:51 PM, antoine drouin <address@hidden> wrote:

Hello

You don't need PPS. It's a timing signal generated by the GPS, which
we're not using at the moment.
About test programs, take a look at the wiki  (
http://paparazzi.enac.fr/wiki/Booz ) , there's already a couple of
things there, which I intend to extend ASAP. Did you flash the
bootloader ?

Regards

Poine

On Wed, Dec 30, 2009 at 8:37 PM, Jayson MacKiddie
<address@hidden> wrote:
> Hello,
>
> I do not understand exactly what the purpose of R48 is in the booz hardware.
> It a 0/DNP on the GPS/Bootloader connector. The comment on the schematic
> reads "Place R48 to connect PPPS to EINT2". What is PPS? is it Bootloader
> programming related?
>
> Regards
> Jayson
>

> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>


_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel

-- 
Jayson MacKiddie