Hi,
We have recently got some TWOG and GPS13 hardware. I have a bench
set-up with a simple flight plan to test some airborne module code I've
written. I'm using the FTDI USB to serial board/cable as the link
between my development PC and paparazzi.
I am finding that the everything starts up fine, waiting for the GPS to
lock, then setting the nav coordinates and advancing to the holding point.
When I double-click on another flight plan block, everything locks up.
I have noticed that at this point the link indicator in the strip starts
counting seconds from zero and then goes red. No more messages get
displayed in the messages tool.
This happens at link baud rates of 9600, 57600 and 115200. (Yes, I do
change the baud rate both for the ground station in control_panel.xml
and autopilot in the makefile section of the airframe file - comms does
work correctly up till this point).
Has anybody encountered this before, or have any idea what might be
happening?
Cheers,
Steve
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel