Hi there
May I ask for some answers to what may seem stupid questions to some before I commit my aircraft to the airwaves.
1) : I have embedded a this camera and transmitter in the wing root of a Multiplex funjet and have added conf/settings/switch.xml to the GCS switch strip.
Will I need to add:
# Video switch
ap.CFLAGS += -DUSE_GPIO
ap.srcs += $(SRC_ARCH)/gpio.c
taken from GlassOne #1 Tiny V1.1" to the conf/airframes/funjet1.xml makefile to operate the switchable 5 v Aux pin on a tiny 2.11 board.
2): What is the logic for employing different throttle/motor settings for different funjet frames? For instance
airframe name="Funjet 1 Tiny 2.1">
<!-- commands section -->
<servos>
<servo name="MOTOR" no="0" min="1000" neutral="1000" max="2000"/>
<servo name="AILEVON_LEFT" no="2" min="1130" neutral="1500" max="1880"/>
<servo name="AILEVON_RIGHT" no="6" min="1980" neutral="1515" max="1170"/>
</servos>
and
<airframe name="FunJet GFI 1 Tiny 1.1">
<!-- commands section -->
<servos>
<servo name="THROTTLE" no="2" min="1550" neutral="1550" max="1900"/>
<servo name="LIGHT" no="1" min="1000" neutral="1000" max="2000"/>
<servo name="AILEVON_RIGHT" no="5" min="1900" neutral="1432" max="1100"/>
<servo name="AILEVON_LEFT" no="6" min="1100" neutral="1546" max="1900"/>
</servos>
And if it's to do with tiny versions are there changes I need to make for a tiny 2.1.1 board.?
Just in case it's important I am using a Futaba T7CAP and intend to use conf/radios/T7cap.xml.
3): Can I replace tiny_ 2_1.h with tiny_2_1_1.h in conf/airframes/funjet1.xml
Thank you in advance
Regards
Stephen L Hulme
_______________________________________________
Paparazzi-devel mailing list
address@hiddenhttp://lists.nongnu.org/mailman/listinfo/paparazzi-devel