paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Route PPM back to RC receiver on tiny2_1_1


From: antoine drouin
Subject: Re: [Paparazzi-devel] Route PPM back to RC receiver on tiny2_1_1
Date: Sun, 22 Feb 2009 03:07:14 +0100

Hi Andre

servo_direct is not meant for that. It's meant to produce a ready to
use servo pulse ( 1-2m/s high , period 25ms) using the PWM hardware of
the LPC
What you want is really servo_4017 or servo_4015 depending on the
driver in your receiver and configure that code for the wiring of the
tiny you're using.


Regards

Poine

On Sat, Feb 21, 2009 at 10:16 PM, Devitt, Andre <address@hidden> wrote:
>
> Is the code to route the ppm signal back to an rc reciever through srv_clk
> and srv_rst functional on a tiny2. I'd like to be able to plug the servos
> directly into the reciever. I've modified my hardware appropriately but
> don't seem to be getting any signal out of srv_clk and srv_rst.
>
> Some of the instructions on wiki seem dated and they don't work. I do get
> different function with servos_direct_hw.h/c but I'm not sure what compile
> time defines are necessary or any other configuration settings.
>
> Thanks,
>    Andre
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>




reply via email to

[Prev in Thread] Current Thread [Next in Thread]