R: [Paparazzi-devel] YAW

[Marco Di Palo]

Thanks,...just another question...
In Paparazzi I haven't to set any information about the aircraft (total
weight, fuel weight...., the aircraft model), neither about the atmosphere
model (static pressure, air density,...), nor about the aerodynamic and
propelling coefficient, the propelling force. Isn't it? 
So Paparazzi can work with almost every type of aircraft (of any weight and
size...)...is it right? 

Regards. 
Marco Di Palo



-----Messaggio originale-----
Da: address@hidden
[mailto:address@hidden Per
conto di Pascal Brisset
Inviato: domenica 14 dicembre 2008 22.57
A: address@hidden
Oggetto: Re: [Paparazzi-devel] YAW

Hi Marco,

there is no YAW "command" computed from the AP. However, you can have an 
action on the rudder from the ROLL "command" through a "combi-switch" 
configuration. For example in minimag1.xml:

    <set servo="RUDDER" value="@YAW + @ROLL*COMBI_SWITCH"/>

where @YAW will be 0 in AUTO2 (*)

--Pascal

(*) Except that the YAW command from the RC is taken into account even 
in AUTO2 :-)

Marco Di Palo wrote:
> Hi,
> I would like to post this question:
> in paparazzi, is the yaw (and so the rudder) managed and calculated by
> the AP, or is it managed olny by manual commands?
>
> Regards.
> Marco Di Palo 
>
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>   



_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel