Hello
I am adding more and more stuff to my Tiny 2.11 and
now it is time for the R/C Receiver.
Unfortunately I have run into some
problems.
The connection is ok and I can see data in the PPM message
and it changes values as I move the stick on the transmitter. But I cant get
any action in reply to my changes on the transmitter. The Tiny does not change
mode (can't get it to leave AUTO2) when I change the 3-state switch and I cant
get any servos to move. Also the "Radio command status"-box always says
NONE.
Probably it is a misconfiguration somewhere but I can not find
it. I have studied the mailing list archives and the "Paparazzi, the RTF
Autopilot" thread on RCgroups.com but I have not found that much at all about
the R/C receiver. Does it usually work right of for people?
The
receiver I use is an Hitec HFS-04MI. It has a 4017 chip. As I wrote, I can see
the values change with the movement of the sticks so I guess that part of
hardware config is ok.
I have attached my airframe and radio files.
Are there any more files that needs to be changed?
If you see anything
strange or faulty in my config files (perhaps not related to this) please let
me know.
Regards
Jesper
Sweden