[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [Paparazzi-devel] Blank GCS frame!
From: |
Simon Jobin |
Subject: |
RE: [Paparazzi-devel] Blank GCS frame! |
Date: |
Wed, 30 Apr 2008 19:42:07 -0400 |
hi,
For your voltage problem, as Anton said this is because your resistor bridge is
wrong. Here are some ways to solve to problem
1) had to your airframe conf file. This will generate warnings because
VoltageOfAdc(adc) is already defined in tiny_2_1.h. The #ifndef i tiny_2_1.h
doesn't help since this file is probably built before.
2)change your resistors bridge for values that respect the ratio in tiny_2_1.h
Simon
________________________________
> From: address@hidden
> Date: Wed, 30 Apr 2008 20:28:28 +0000
> To: address@hidden
> Subject: RE: RE: [Paparazzi-devel] Blank GCS frame!
>
>
> Yes, u-center defaults to temporary settings, you must check the box to make
> it permanent and you may need to upload the settings twice if the baud rate
> change causes the upload to fail. Power cycle it to be sure it holds the new
> settings.
>
> The tunnel code allows u-center to see the gps, this is the only purpose of
> the tunnel - to bypass the autopilot and communicate directly with the gps.
> When you flash with regular code, only the autopilot can communicate with the
> gps and it will send pprz data down the serial port that only the pprz GCS
> can interpret.
>
> -- address@hidden wrote:
>
> When you use Ucenter, you must click a box to save to flash memory. I dont
> quite remember where, but I think its on the wiki.
>
> AJ
>
> -------- Original Message --------
> Subject: Re: RE: [Paparazzi-devel] Blank GCS frame!
> From: Mohammad Ali Haji Pour
> Date: Wed, April 30, 2008 7:59 am
> To: address@hidden
>
> BTW I forgot to mention that after uploading the code into the AP, I cannot
> get anything from GPS in the u center with the FTDI cable.
>
> Best Regards,
>
> Mohammad
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
> _____________________________________________________________
> Click here for free information on consolidating your debt.
_________________________________________________________________
Branchez-vous à Windows Live Messenger et inscrivez-vous afin de courir la
chance de gagner 1000$ chaque jour jusqu’au 12 mai. Visitez connectezetgagnez.ca
http://g.msn.ca/ca55/221
- Re: [Paparazzi-devel] Blank GCS frame!, (continued)
- Re: [Paparazzi-devel] Blank GCS frame!, Pascal Brisset, 2008/04/27
- RE: [Paparazzi-devel] Blank GCS frame!, akochevar, 2008/04/28
- Re: [Paparazzi-devel] Blank GCS frame!, address@hidden, 2008/04/28
- Re: [Paparazzi-devel] Blank GCS frame!, Mohammad Ali Haji Pour, 2008/04/29
- RE: [Paparazzi-devel] Blank GCS frame!, akochevar, 2008/04/29
- RE: RE: [Paparazzi-devel] Blank GCS frame!, akochevar, 2008/04/30
- RE: RE: [Paparazzi-devel] Blank GCS frame!, address@hidden, 2008/04/30
- RE: [Paparazzi-devel] Blank GCS frame!,
Simon Jobin <=