You must configure many settings on the gps - it will not work as-is. There is a file on the wiki that you can send to the GPS from u-center that will change all the required parameters as well as the baud rate. The wiki file may set it to 19.2 but 38.4K is recommended.
-- "Tom Apker" <address@hidden> wrote: Hello,
I'm trying to get a few new Tiny1.1 boards working, and it seems like everything but the GPS works.
The wiki suggests setting the UART1 baud rate to 38,400, while the airframe configuration files that use the Tiny seem to have it set at 19,200. I'm using a uBlox LEA-4P, and haven't run any special configuration on the GPS unit itself. Do I need to do that to use a baud rate higher than 9600? Alternatively, can I just set the -DUART1-BAUD=9600 and have a working system?
Many thanks,
Tom Apker
_______________________________________________ Paparazzi-devel mailing list address@hidden http://lists.nongnu.org/mailman/listinfo/paparazzi-devel