Hi Anton,
Thats a good point you rased! I looked again, and now I don't know what layers I need to select when I generate the gerbers. I'm still waiting for Dr
Heinrich to mail me the gerbers, this solves all my problems. When I run the cam job, I see only component side and solder side, and the silk screens, I don't see other layers. There are 2 layers that confuse me, Route 2 and Route 15, I wonder if these are the 2 layers I'm missing. Are the 2 layers in between a signal layer, and a ground layer?
-Thanks,
Uttam
----- Original Message ----
From: "address@hidden" <address@hidden>
To: address@hidden
Sent: Wednesday, November 28, 2007 5:46:13 PM
Subject: RE: [Paparazzi-devel] Paparazzi Tiny13 help
Uttam,
Although you cannot create or edit files in the free version of Eagle, Im pretty sure you can view all 4 layers, and even create gerbers from them.
Anton
-------- Original Message --------
Subject: Re: [Paparazzi-devel] Paparazzi Tiny13 help
From: Uttam Chandrashekhar <address@hidden>
Date: Wed, November 28, 2007 2:18 am
To: address@hidden
Hello Boris,
I think Christian VEYSSIERE from France mentioned about this! I hope this is not going off-topic on the forum, I will mail you offline.
-Thanks,
Uttam
----- Original Message ----
From: Boris Bataille <address@hidden>
To: address@hidden
Sent: Wednesday, November 28, 2007 2:21:26 PM
Subject: Re: [Paparazzi-devel] Paparazzi Tiny13 help
Hello Uttam,
However, we experienced some problems with some speed controllers that could not run the motors correctly.
What speed controllers do you recommend for the best performance and do you have performance datas of your egines?
Boris
Get easy, one-click access to your favorites. Make Yahoo! your homepage.
_______________________________________________
Paparazzi-devel mailing list
Paparazzi-devel@nongnu.org
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel