Re: [Paparazzi-devel] Classix BOM help

[address@hidden]

David,

Very few Classix boards have been produced and no one has created a BOM yet as the Classix is really just a developer's board, intended for very sophisticated payload applications and was always assembled using available Tiny components.  Almost all of the parts are the same as Tiny equivalents so you can figure it all out thru a tedious comparison of schematics and part numbers.  Sorry that there is no easier way, but if you do create a BOM, please post it on the Wiki for future builders.

Jeremy

-- David Conger <address@hidden> wrote:
Need assistance: Classix BOM conversion to Digikey/Mouser/? part numbers
Problem: The Wiki says:
 "The materials list can be produced from the Eagle CAD files on the  
downloads page."
Simple enough, that creates something like:
(Below is a partial output):
Qty Value        Device            Parts
2                CPOL-EUA/3216-18R C7, C18
1                D-SOD-80          D1
4                LEDCHIP-LED0805   LED1, LED2, LED3, LED4
1                SJ2W              SJ1
4   1K           R-EU_R0603        R23, R24, R25, R26
1   1nF          C-EUC0603         C26
1   330uF        C-EUC0603         C23
1   4.7K         R-EU_R0603        R8
16  100nF        C-EUC0603         C1, C2, C3, C4, C5, C6, C9, C10,  
C11, C12, C14, C17, C19, C20, C21, C22
1   100pF        C-EUC0603         C24
1   CRYSTAL_CTS  CRYSTAL_CTS       U$20
2   REG1117      REG1117           IC1, IC2

Now if I had manufacturers part numbers I can do the search as all  
suppliers have that. My request is for someone to put the  
manufacturers part numbers or some suppliers part number onto the  
Wiki or a link to a BOM for Classix, GPS13 and other Eagle Files for  
Paparazzi. Is this possible?
Regards,
David


_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel