Re: AW: [Paparazzi-devel] Commercial boards

[Antoine]

Hi Ethan

I think fully populated and tested boards would be the best - The arm 
boards ( classix and tiny) use fine pitch part ( 0.5mm ) which are very 
difficult to solder without proper equipment ( at least hot air).

What do others think ?

Regards

Antoine



Ethan Arnold wrote:
> Hi Antoine,
>
> Are you looking just at PCB's or fully populated and programmed boards?
> I'd be happy to produce and market the PCB's, and I think I can probably
> find a way to get them assembled (at least with the components that are
> impossible to do manually), although I'd still need to do some reasearch to
> make an estimate for that.
>
> Regards,
> Ethan
>
>
> -----Ursprüngliche Nachricht-----
> Von: address@hidden
> [mailto:address@hidden Im Auftrag von
> Antoine
> Gesendet: Sonntag, 30. Juli 2006 21:04
> An: address@hidden
> Betreff: [Paparazzi-devel] Commercial boards
>
> Hello world
>
> We are trying to find a way to get ready made boards commercially available.
> Gumstix said they would do it but seems very slow to do so.
> If you know a company that would provide this service please let us know.
> In the same time we have setup a page on the wiki to collect buying 
> intentions and get an estimate of the needed volume.
>
> Please edit this page : 
> http://www.recherche.enac.fr/paparazzi/doc/moin.cgi/Dev/CommercialBoards
>
> Best regards
>
> Antoine
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>