Re: radius syntax?

[Len Conrad]

>On 10/10/2012 1:16 PM, Len Conrad wrote:
>> the doc says:
>>
>> check process radiusd with pidfile /var/run/radiusd.pid
>>        start program = "/etc/init.d/freeradius start"
>>        stop program = "/etc/init.d/freeradius stop"
>>        if failed host 127.0.0.1 port 1812 type udp protocol radius 
>>            secret testing123 
>>        then alert
>>
>> my config is (monit 5.5, fbsd 8.2), xxx.4.63.16 is the local host:
>>
>> check process rad1.xxx.net-RADIUS with pidfile /var/run/radiusd.pid   
>>   start program = "/usr/local/etc/rc.d/radiusd start"
>>   stop  program = "/usr/local/etc/rc.d/radiusd stop"
>>   if failed host xx.4.62.16 port 1812 type udp protocol radius
>>      secret testing123
>>   then alert      
>>
>> this always fails, from the monit.log:
>>
>> [CDT Oct 10 13:11:49] error    : 'rad1.xxx.net-RADACCT' failed protocol test 
>> [RADIUS] at INET[xx.4.62.16:1812testing123] via UDP -- RADIUS: error sending 
>> query -- No route to host
>>
>> Len
>
>Is the network intended to be different?  Third octet  62 vs 63?

a typo, should be xx.69.4.62.16

Len







>  -- Noel Jones
>
>--
>To unsubscribe:
>https://lists.nongnu.org/mailman/listinfo/monit-general