Dear Support,
I would like to have some help from you about the GNU make 3.80 under
Windows.
When executing this part of Makefile :
# Dependency update target
#-------------------------
depend:
@chmod a-r makefile*
@cp makefile makefile.old
@sed '/^# Dependencies follow/,$$d' makefile.old >
makefile
@echo "# Dependencies follow" >> makefile
$(CC) -E -M $(CINC) $(SOURCES) >> makefile
@echo "# IF YOU PUT STUFF HERE IT WILL GET BLASTED" >>
makefile
@echo "# see depend: above" >> makefile
where CC = pl16cc (which is a DSP compiler)
the following error message occurs:
pl16cc -c -mdata-sec-.DSECT,mydata -E -M -ID:\palm16\include -I.
-ID:\Philips\Idk\Shl\Include D:\palm16\libs\Crt0.c D:\palm16\libs\Crtn.c
Main.c >> makefile
C:\TEMP\make3145.sh D:/palm16/pl16cc.exe: Not enough memory
(ENOMEM)
make: *** [depend] Error 126
My trouble is that if I execute directly this command it works fine ?!??!
Do you have any idea about where does it come from ?
Thank you for your help.
Best regards,
Patrice.
\\\-|-///
( o o )
----------------------------------oOOo-(_)-oOOo----------------------------------------------
Patrice BOYRON..............................................Philips
Semiconductors Sophia SAS
SoC Senior SW Engineer..............................BU Mobile Com./BL
Cellular Infrastructure
......................................................................505,
Route des Lucioles
Phone : +33 (0)4 92 96 12 82............................06560 Valbonne -
Sophia Antipolis
Fax : +33 (0)4 92 96 12
72.......................................................FRANCE
Email : address@hidden
.oooO
----------------------------------- ( )-- Oooo.
-------------------------------------------
\ ( ( )
------------------------------------------------------------------------
_______________________________________________
Make-w32 mailing list
address@hidden
http://mail.gnu.org/mailman/listinfo/make-w32